Analogue settable 2-stage ON-delay, 1+1 NO contact 10A
In stock price (excl. VAT):
50,11 €
This price is valid until 2024-12-31
Price per m:
50,11 €
EAN: 4010312603178
MPN: 23200302
Our warehouse:
No
Vendor stock:
No
Per package:
1
Per box:
1
Per pallet:
N/A
Technical data
| Item condition | New |
| Manufacture name | Analogue settable 2-stage ON-delay, 1+1 NO contact 10A |
| Brand | ELTAKO |
| Categories |
Relays |
| Country of origin | CN |
| Harmonized System Code | 8536 4900 00 |
| Mounting method | DIN rail |
| Function | Additive operating delay |
| Built-in height | 58 mm |
| Type of excitation | Analogue with single function |
| Width in number of modular spacings | 1 |
| Number of changeover switches | 0 |
| Control voltage 1 | 8-230 V |
| Control voltage 2 | 8-230 V |
| Type of control voltage 1 | AC/DC |
| Type of control voltage 2 | AC/DC |
| Frequency control voltage 1 | 50 Hz |
| Voltage type of supply voltage | AC/DC |
| Supply voltage | 8-230 V |
| 1st interval unit | Seconds/minutes |
| 2nd interval unit | Seconds/minutes |
| 1st interval | 0-60 |
| 2nd interval | 0-60 |
| Switch capacity incandescent lamps | 1000 W |
| Switch capacity fluorescent lamp DUO | 500 VA |
| Switch capacity fluorescent lamp parallel | 250 VA |
| Number of contacts as normally closed contact | 0 |
| Number of contacts as normally open contact | 2 |
Packing details
| Packing level 1 | 4010312603178, 4010312603178 |
| Packing level 2 | 4010312603178 |
| Packing level 3 | 4010312603178 |
Downloads
Description
2-stage ON-delay. 1+1 NO contact potential free 10A/250V AC. 230V LED lamps up to 200W, incandescent lamps 1000W. Standby loss 0.4 watt only. Modular device for DIN EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Universal control voltage input 8 to 230V UC. Supply voltage is same as the control voltage. Contact position display with two LEDs. Very low switching noise. By using a bistable relay coil power loss and heating is avoided even in the on mode. The switched consumer may not be connected to the mains before the short automatic synchronisation after installation has terminated. In case of a power failure the system is disconnected in a preset sequence. When the control voltage is applied, the time lapse T1 starts between 0 and 60 seconds. At the end of the time lapse, contact 1-2 closes and time lapse T2 starts between 0 and 60 seconds. At the end of this time lapse, contact 3-4 closes. After an interval, the time lapse starts again at T1.