Multifunction impulse switch with integrated relay function, 1 + 1 NO contacts 10A

Item condition	New
Manufacture name	Multifunction impulse switch with integrated relay function, 1 + 1 NO contacts 10A
Brand	ELTAKO
Categories	Relays
Country of origin	CN
Harmonized System Code	8536 5080 00
Mounting method	Flush mounted (plaster)
Function	Other
Built-in depth	58 mm
Control voltage 1	8-230 V
Control voltage 2	10-230 V
Type of control voltage 1	AC
Type of control voltage 2	DC
Frequency control voltage 1	50 Hz
Frequency control voltage 2	50 Hz
Suitable for manual operation	No
Voltage type of supply voltage	AC/DC
Supply voltage	230 V
Max. switching current (cos phi = 0.6)	8 A
Max. incandescent lamp load	2000 W
Max. load fluorescent lamp	1000 VA
Max. load fluorescent lamp (Duo circuit)	1000 VA
Max. load fluorescent lamp (parallel compensated)	500 VA
Rated switch current	16 A
Number of contacts as normally closed contact	0
Number of contacts as normally open contact	2
Number of contacts as change-over contact	0

Packing level 1	4010312108079, 4010312108079
Packing level 2	4010312108079
Packing level 3	4010312108079

1+1 NO contacts potential free 10A/250V AC. 230V LED lamps up to 200W, incandescent lamp load up to 2000W. No standby loss. For installation. 45mm long, 45mm wide, 32mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Universal control voltage 8 to 230V UC. No permanent power supply necessary, therefore no standby loss. By using bistable relays coil power loss and heating is avoided even in the on mode. The switched consumer may not be connected to the mains before the short automatic synchronisation after installation has terminated. The functions of the second rotary switch are preselected using the rotary switch ES/ER. The setting ER selects the function in brackets. 10 different functions are selectable. 2S = Impulse switch with 2 NO contacts. (2R) = Switching relay with 2 NO contacts. WS = Impulse switch with 1 NO contact and 1 NC contact. (WR) = Switching relay with 1 NO contact and 1 NC contact. SS1 = Impulse multi circuit switch 1+1 NO contacts for switching sequence 0 - contact 1 (1-2) - contact 2 (3-4) - contacts 1+2. (RR) = Switching relay (closed-circuit current relay) with 2 NC contacts. SS2 = Impulse multi circuit switch 1+1 NO contacts for switching sequence 0 - contact 1 - contacts 1+2 - contact 2. (EW) = Impulse relay for fleeting NO contact with 1 NO contact and 1 NC contact, wiping time 1 sec. GS = Impulse group switch 1+1 NO contacts for switching sequence 0 - contact 1 - 0 - contact 2. (GR) = Group relay 1+1 NO contacts (relay with alternating closing contacts). This relay is not suitable to feed back the switching voltage signal of a dimmer switch. Use only relays ESR12DDX-UC, ESR12NP-230V+UC or ESR61NP-230V+UC for this purpose. The electronics does not have an internal power supply and therefore no power is consumed in any contact position. A control current flows only during a short control impulse of 0.2 seconds. This activates the microcontroller, reads the last switching state from the non-voltage memory, switches the bistable relay to its opposite state accordingly and rewrites the new switching state to memory.