Wireless actuator multifunction time relay

Item condition	New
Manufacture name	Wireless actuator multifunction time relay
Brand	ELTAKO
Categories	Switches
Country of origin	CN
Harmonized System Code	8526 9200 00
Mounting method	Flush mounted (plaster)
Colour	Blue
Halogen free	Yes
Surface protection	Other
Current supply	230 V AC
Number of relays	1
Suitable for switch	Yes
Suitable for pulse button	Yes
Suitable for dimmer	No
Suitable for roller shutter switch	No
Material quality	Thermoplastic
Material	Plastic
Type of fastening	Other
Rolling code system	Yes
Number of commands	32
Radio frequency	868 MHz
In housing	Yes
In tube base housing	No
Printed circuit board/module	No
Push button mode	Yes
Switching mode	Yes
With manual radio transmitter	No
With radio coding device	No
With radio controlled push button	No
Suitable for venetian-/roller shutter switch	No
Suitable for venetian shutter switch	No
Transparent	No
Surface finishing	Matt
Suitable for degree of protection (IP)	IP20
IFTTT support available	No
Compatible with Apple HomeKit	No
Compatible with Google Assistant	No
Compatible with Amazon Alexa	No

Packing level 1	4010312302293, 4010312302293
Packing level 2	4010312302293
Packing level 3	4010312302293

1 NO contact potential free 10A/250V AC, 230V LED lamps up to 400W, incandescent lamps up to 2000 watts.* Encrypted wireless, bidirectional wireless and repeater ­function are switchable. Only 0.8 watt standby loss. For installation. 45mm long, 45mm wide, 33mm deep. Supply voltage and if necessary control voltage locally 230V. If a power failure occurs, the switching state is retained. If a power failure occurs repeatedly, the device is switched off in a defined sequence. This wireless actuator features state-of-the-art hybrid technology that we developed: we combined the wear-free receiver and evaluation electronics with a bistable relay. By using a bistable relay coil power loss and heating is avoided even in the on mode. After installation, wait for short automatic synchronisation before the switched consumer is connected to the mains. In addition to the wireless control input via an internal antenna, this wireless actuator can also be controlled locally by a conventional control switch if fitted previously. Glow lamp current is not permitted. You can teach in encrypted sensors. You can switch on bidirectional wireless and/or a repeater function. Every change in state and incoming central command telegrams are confirmed by a wireless telegram. This wireless telegram can be taught-in in other actuators, Professional Smart Home controllers and in universal displays. With the top rotary switch in the setting LRN up to 35 wireless pushbuttons can be ­assigned, of which one or more central control pushbuttons. In addition, wireless window/door contacts (FTK) may have a NO or NC function when the window is open. If a direction pushbutton is taught-in, a function (e.g. TI) can be started using the top key (START) and stopped with the bottom key (STOP). The required function can then be selected. Switching will be visualised by flashing of the LED. RV = off delay. AV = operating delay. TI = clock generator starting with impulse. IA = impulse-controlled operating delay. EW = fleeting NO contact. The bottom rotary switch sets the time from 0.5 seconds to 60 minutes. The LED performs during the teach-in process according to the operating instructions. It shows wireless control commands by short flickering during operation. * The maximum load can be used from a delay time or clock cycle of 5 minutes. The maximum load is reduced for shorter times as follows: up to 2 minutes 30%, up to 5 minutes 60%.