Registruokitės, kad atrakintumėte savo išskirtines B2B kainas ir pradėtumėte apsipirkinėti. Užsiregistruokite dabar!
Transmitter module with batteries image 1
ELTAKO

Transmitter module with batteries

Yra sandėlyje: Ne Pardavėjo atsargos: Ne Minimalus užsakymo kiekis: 1
Kaina (be PVM):
62,98 €
Ši kaina galioja iki 31.12.24
EAN: 4010312316092
MPN: 30000459
Pakuotė: 1

Technical Information

Prekės būklė Nauja
Gamintojo pavadinimas Transmitter module with batteries
Prekės ženklas ELTAKO
Kategorijos Jungikliai
Kilmės šalis CN
Suderintos sistemos kodas 8526 9200 00
Srovės tiekimas Baterija
Perdavimo diapazonas 30 m
Ritininio kodo sistema No
Komandų skaičius 1
Lygiai montuojamas radijo siųstuvas No
Prie paviršiaus montuojamas radijo siųstuvas No
Klaviatūros apsaugos gaubtas No
Radijo dažnis 868 MHz
Su rankiniu radijo siųstuvu No
Su radijo kodavimo įrenginiu No
Saugos laipsnis (IP) IP20

Pakavimo informacija

Pakavimo lygis 1 4010312316092, 4010312316092
Pakavimo lygis 2 4010312316092
Pakavimo lygis 3 4010312316092

Atsisiuntimai

Gilios nuorodos į produkto puslapį

Aprašymas

Wireles transmitter module with batteries and antenna rod. LxWxH: 60x46x30mm (dimensions excluding antenna and fixing screws). This wireless transmitter module can be operated by a water sensor FWS60 or a pushbutton and transmits a variety of adjustable wireless telegrams to the Eltako building wireless system. An internal jumper permits selection between 4 operating modes. In mode 1 (jumper plugged at Position JP1) wireless telegrams is sent from a wireless pushbutton, such as Press double rocker at bottom left. In mode 2 (jumper plugged at Position 2) wireless telegrams is sent from a wireless push­button, such as Press double rocker at top right and bottom right. In mode 3 (jumper plugged at Position 3, factory setting) wireless telegrams is sent to EnOcean Standard EEP A5-30-03. In mode 4 (jumper plugged at Position 4) wireless telegrams is sent to EnOcean Standard EEP A5-30-01. In modes 3 and 4 a status telegram is also sent every 33 minutes. The power supply that lasts several years is provided by an internal 3V button cell CR2032. The charge status of the battery is transmitted in every data and status telegram in mode 4. Press the internal LRN button to teach in the actuator which is ready for teach-in. Release two screws on the front to ­remove the cover. When closing, make sure the seal is in the correct position. An M12 screw is located on the underside to connect the cable. It is not permitted to activate several wireless transmitter modules at the same time.